Funny, I must have been thinking I may need a gun to get it out? But is there a trick to getting it back in?
Thanks,
Peter in Austin
Search found 3 matches
- Sun Sep 25, 2011 7:15 pm
- Forum: Post 1970 Airheads
- Topic: 40mm Caliper stuck, need to rebuild
- Replies: 7
- Views: 1024
- Sun Sep 25, 2011 5:48 pm
- Forum: Post 1970 Airheads
- Topic: 40mm Caliper stuck, need to rebuild
- Replies: 7
- Views: 1024
Re: 40mm Caliper stuck, need to rebuild
Success. Must not have had the regulator turned up enough or that and a combination of several attempts. But it popped out, not pitted that bad, minor, enough to see if it will seal. It cleaned up pretty well. Now of course I can't figure out how to get it back in. The outer seal rolls back, and I c...
- Sat Sep 24, 2011 2:06 pm
- Forum: Post 1970 Airheads
- Topic: 40mm Caliper stuck, need to rebuild
- Replies: 7
- Views: 1024
40mm Caliper stuck, need to rebuild
Hello, I ran into a problem while converting over to dual discs on my bike. Bought a used right side slider/caliper and the caliper is rusted tight. Can't get any movement out of the piston. Tried compressed air, no luck. Now I have it on the bench hooked up to a master cylinder trying to force it f...