Boxerworks.com

Well the flasher on my /6 has finally bit the bullet. Took it apart and no amount of tinkering can get it to work correctly. Hense my question. Is there a replacement other than the $94.00 BMW part

Are you talking about part 61 31 1 358 194? Apparently, there's a car part for the 2002 BMWs that can be used - 61 31 1 364 984. Hella also has something - 4DB 003 425-017 and 4DB 003 425-001. I pulled this from Joe Cuda's article that used to be on the Airheads website.

Kurt in S.A.

When my flasher stopped cycling to blink the lights, I resoldered (reheated and added solder) all the connections and component attachment points on the board. Started flashing again.
worth a try.

gg

What model/year is your bike?? OOps just saw you /6 model....so follow first set of instructions that follow

You can use a standard Stant/Tridon flasher unit for car application as substitute but... There're about $5-7,00 at any auto parts place.

For earlier flasher relay having 4 terminals #49,49a, KBL and 31 you'll need a 3 terminal flasher unit...

Wire this up as follows (after putting new female lugs on wires)

New relay (3 prong type)

Terminal P = Blck/White wire - (goes to dash turn indicator) - old relay # KBL
Terminal L = Green/Yellow wire - (Load - to signal indicators) - old relay #49a
Termina X = Green/Black - (+12v) - old relay #49

The left over wire is old terminal #31 (ground) - don't need - just tape it off

For newer flasher relay having 3 terminals # 49, 49a and 31 - need 2 prong flasher relay

New flasher terminal ( 2 prong type)

One terminal - attach Green/Blck wire (old terminal #49 connection

Other terminal _ Green Yellow wire (old terminal #49a connection

NOTE: Doesn't matter which wire (Gr/BL or Gr/Y goes to first)

Left over wire from old flasher relay should be Brown (old terminal #31) - just tape off - not used

Hope this works - from my old notes - I used on both a 75 R75/6 (4 terminal flasher) and other on 82 RS (3terminal flasher)...good luck

This should work...but keep in mind tht these new flasher units don't indicate if you have a burned out bulb as the old flasher relays did but flashing at faster rate)...they just keep flashing in spite of 1 burned out bulb..

I once was a flasher and it cost me nothing.

Diane, the skank, gets paid for it.......... and more.

Hi painter!

Hey Rob , Hi back at ya I looked up the flasher no, that Kurt gave me on the BMW 2002 car ,it was only $ 4.00 cheaper than the oem for the bike. Could not find any info on the Hella part no. either. I would be happy to substitute it with Duane, but I need it to blink on the left every once in a while! Moosehead, Thanks for you info, but you lost me a little bit there.

If you think he can use a relay off of a R65 (/7-ish), I have one for the price of a forum donation.
But I will need help figuring out which one it is.... It came with a T.S. buzzer, and there is a relay in the description for that.
I have one in my hands. It has 4 contacts; 30 & 87a are the switched contacts (open/close) and 85 & 86 energize the circuit. On the side it says 1 243 560.3 and a date of mfg. - 11/78.
Needs cleaned up.

http://www.realoem.com/bmw/showparts.do ... g=61&fg=33




No. Description Supplement Qty From Up To Part Number Price Notes Photo
01 Horn 1 61331243486 +core, ENDED
02 Hex bolt M8X16 3 07119901190 ENDED
02 Hex bolt M8X16-8.8-ZNS3 3 07119902900 $0.36
03 WAVE WASHER B8 3 07119932121 ENDED
04 Washer A8,4-ZNS 1 07119931019 $0.40
05 STOP LIGHT SWITCH 1 61311353684 $58.32 +core
06 Cap 1 61311351249 $8.61
07 Fillister head screw M4X12 2 09/1982 07119907663 ENDED
07 Fillister head screw M4X12 2 09/1982 07119900692 $1.80
08 WAVE WASHER B4 2 09/1982 07119932033 $0.09
09 BUZZER 1 08/1979 61311243490 ENDED
FOR BUZZER
10 Relay 1 08/1979 61311373916 $23.75
FOR FLASHER
11 HAZARD WARNING RELAY 1 61311244392 $40.98 +core
FOR DAY-LIGHT-DRIVING
12 Relay GELB 1 61311373585 $23.75

FOR STARTER
13 Relay in zinc yellow 1 61361389105 $23.75 +core
14 INSTALLING SET DOUBLE SIGNAL HORN 1 61331243889 +core, ENDED
15 Horn 420HZ 1 61331243710 $60.79 +core
16 Bracket 1 61331243743 $23.70
17 WIRING DUAL HORN 1 61121243752 $48.15 +core
18 Cable strap L=200MM/B=3,6MM 1 61131367599 $0.43

19 STOP LIGHT SWITCH 1 61311244070 $13.70 +core
20 Shackle 1 61332306792 $4.35

Well, I never considered myself the dullest knife in the drawer , but when it comes to lectrics I am not to sharp. After reading mooseheads post and following the thread he gave, the light bulb finally came on .Rob Thanks for your offer. I did look on the site but did not see where or how to make a donation. Please send in the right direction for that

painter.724 wrote:Well, I never considered myself the dullest knife in the drawer , but when it comes to lectrics I am not to sharp. After reading mooseheads post and following the thread he gave, the light bulb finally came on .Rob Thanks for your offer. I did look on the site but did not see where or how to make a donation. Please send in the right direction for that

I would want to make sure it works, first (chime in, guys?),
Does it look like it would work to you, painter?

To donate to Matt through Paypal, his email address is: matt@boxerworks.com

I will probably also need your mailing address again, painter, if this part does work out.