This is a before and after picture of the clip ons I made for my Cafe Racer. Slow progress with all my other projects going on, but it has been powder coated and the bar itself, which is held into the clamping part with a wedge, has been chromed.
Here is a picture of the side stand, which is a stock stand with the unnecessary parts removed and a foot added (actually, just under an inch) and a prong to make it easier to deploy. The prong has yet to be chromed.
Chuey
This is another shot of the same control. It shows the area that was removed to make the wooden cap flow better into the shape of the defunct choke lever.
Here is a tool I made to brace the crankshaft when the alternator is off. I'm glad to have it, as I've used it twice now. This picture is the engine which I'm doing a clean-up and tidy up on. So far, new clutch friction plate, main and oil pump seals, heads refurbished, carbs rebuilt, and much cosmetic stuff.
